Pair of early style airguide speedometers. They both worked when removed from my 73. Black faces with white numbers. Adjusting knobs both broke...
Since I didn't take the top off it saved a lot of time. Honestly the hardest part was fitting the wood and getting the mercruiser transom parts...
[ATTACH] Back in service with no issues. 2nd test run today. The alpha gimbal housing took care of all the annoying issues I had with the old mc1...
Well the motor went back in today. Aligned with the tool just fine. I found a defect in the bellows so I'll be replacing them next week. I have...
Got the transom in today. I'll Put a layer of glass over it then tab it in later this week. Have any other I/o owners moved the plug to the middle?
I know it was 2 sheets of 3/4. 3 sheets of 1/2 will actually be better due to nominal lumber dimensions. 1/2 inch is only 15/32. It will give me...
I'm fairly certain that I took out two layers of 3/4 inch plywood. The transom did measure 2 inches on top and in the keyhole cutout. I only have...
2 layers of 3/4
I found this placard somewhere in there. Is it of any significance? I'm done grinding out the old wood, sanding the glass and will be making the...
i was planning on using a 2x12 on the outside to clamp and temporarily bolt the inner plywood to during layup. What is the best way glue the two...
So I have most of the wood out. Not a fun job. It apears that the rear plywood sheet went down all the way to the hull and the forward sheet sat...
[ATTACH] Here's a long story I have a 1973 Hydrodyne 18 with the 888 mercruiser I/o drive and 302 ford engine. I have had the boat for several...
Separate names with a comma.