A quick you are welcome for the thanks. I should note that this happened because I posted in 2008 about improving Quicksilver 3000 series...
Take the throttle slide out. [IMG] Loosen the throttle drag adjustment, this screw is on the outside of the controller. [IMG] Remove the throttle...
A few years ago, I got some used Yamaha 704 controllers for our ski teams Twin rig, with Mariner engines, one counterrotating. Before you start...
That was a really nice, pretty, smooth, flowing swivel run. Good job, Pam. I am on Portland Water Spectacular, and on July 6, we are doing a...
Here is how you check the fuel pressure on a Ford GT-40 engine, which I believe your Grand Sport Inboard Hydrodyne has....
Re: 1996 Grands Sport Elite - Fuel Pump High and Low Pressur I am pretty sure all GT-40 marine engines use electric low pressure and high...
Thanks for the reply. I am thinking that is the way we may have to go.
I am looking for a cover for a 20 foot twin rig. Hopefully the second time this question is asked, somebody will respond.
I would suggest removing the deck is a better way to go on the boat, especially if you have to work on the floor also. If your friend, who does...
I have replaced the floor on two Hydrodyne twin rigs so far. I believe that is most of the Hydrodyne twin rigs west of the Rockie mountains....
Start to look for Volvo-Penta dealerships in your area. They would be you best bet for having the special tools to work on it. Is there a problem...
It would help if we knew what the make of the outdrive was.
I maybe can give a partial answer to the last question. I believe in the 1960's serial (or Hull Identification numbers) numbers were random,...
The cables are happier the larger, and fewer bends you can put in them. At the engine end, large ugly loops help, so that there is a lot of area...
You cannot shift the engines without turning either the engine, or the propeller. When the lower unit is shifted into gear, a collar that slides...
Based on my experience with a 1989 and a 1992 Hull, are you sure the floor and transom are in good shape?
A very common propeller on a direct drive ski boat is a 13" diameter, 13 Pitch propeller. There are other details you need to know. Is the...
Can you tell us what engine is in the boat? What transmission?
Most Hydrodynes are used for show skiing. Show skiing driving is completely different than driving a slalom course. On the most basic level,...
Why stop at four engines?
Separate names with a comma.