Is the Hydrodyne still available in very interested 905-658-9599 or craigworkman2@gmail.com. Thanks
Trying to find the location of the lake. How far from buffalo ny I live just over the border and may be interested in bringing my boat over for...
anybody have an original pylon or measurements of an original pylon for a 1970's hydrodyne outboard
thanks for all reply's I guess for now Ill go with it was made in Canada and go with 1985. Does anybody know who bought the molds and produced the...
Hydrodyne finally gets her stripes after 30 years[ATTACH]
Still not sure about the raised floor I believe the floor was mounted right on the stringers. Yes I made the rope Guard copied from a master...
Yes I'm from canada I bought the boat as a bare hull with no engine or seats. After installing the engine it ran terrible anything over 35 mph...
Not sure about the floor if it was basa or plywood. It looked like plywood with carpet. The stringers were also replaced which didn't look much...
The id tag is just under the gunnel starboard side where you would expect it to stamped in the hull Also few of my favourite pictures of I guess...
[ATTACH] [ATTACH] [ATTACH]
This is the id plate on the transom looks like with id number HD180785[ATTACH] Does this look like an original Hydrodyne I'd plate before they...
Yes the picture in the avatar is my boat but I will get some more pictures posted thanks
I was going to take a picture of the tag but it was kind of corroded. It is a aluminum block with those numbers stamped into it on the transom...
Thanks Bob and Jim for the information my serial number is HD 180785 so I guess I assumed it was a1985
Can't seem to open old posts they say errors. Question why do you say this is older then a 1985? I haven't looked at the tag for several years....
Decided to upgrade my 85 dyne. It never had the bow stripes I see them in different configurations. What is correct way blue closer to the bow or...
Separate names with a comma.