Mike, Wow, great pictures! What a beautiful installation. I hadn't seen the uflex cylinder before. It looks like the better option due to the...
Thank you! The final install pictures would be great. My 135s have no hydraulics, they are manual tilt. I wouldn't mind adding power...
Bob, Were you able to fit the SeaStar on the twins in the original splash well? Single cylinder, I guess? I want to do that with my '69 '18,...
I guess it's a moot point, as the '18 splash well doesn't meet the width requirements for twins with the SeaStar. Any other ideas?
Has anyone installed a hydraulic steering system on Mercury inline sixes? I was intending to use a SeaStar front mount cylinder on my '70 twin...
Another question that I think I've seen the answer to, but can't find: Is the end grain core on the later boats 3/4" thick? Thanks, Dave
Ok. Thanks
Will do. Thanks.
Ok, Half inch it is, probably marine grade, definitely resined. Will use woven roven on transom and core. Probably something smoother (bias...
Ok, the core is nearly out and the deck is almost ready to remove. It's time for supplies, which means questions too. I'd like anyone's thoughts...
Wow, that's beautiful. Where did you get your seats and upholstery? Thanks, Dave
Jim, I have a couple questions. 1. Why is a deeper well needed for the inline sixes? 2. You have a wrap around plate; is this to raise the...
TJ, Those look good! I think I could switch mine, but they work fine as is. They don't have the squeeze releases. There are spacers between the...
TJ, Thanks. I will. Dave
Jim, Responded before I saw the link. It looks great. Thanks, Dave
Yes.
Does anyone know a good source for Mercury parts, especially internal wiring harness? Thanks, Dave
Jim, I intend to put the floor as low as possible and seat as far right. However the dual throttle controls may limit how far right. I'm...
TJ, Oops, hit the wrong button. I happen to have nothing on Saturday and would love to see it. Dave
Separate names with a comma.