ECM Needed for my '94 Ford inboard!!!

Discussion in 'Engine Questions' started by T.C. Cameron, Jun 25, 2018.

  1. T.C. Cameron

    T.C. Cameron New Hydrodyner

    Joined:
    Jun 25, 2018
    Messages:
    1
    Boat Model and Year:
    1994 Hydrodyne Grand Sport
    Ski Team:
    Severn River Ski Club
    Looks like I need to replace the ECM in my 1994 Ford inboard PMC Marine Power/mod PCM 40 Serial 93-07251... My port injected is experiencing a "lean pop" and the back end of the ECM is, get this, melting!

    Any suggestions for where I might find this part? I'm getting frustrated...
     
  2. Tom_H

    Tom_H Hydrodyner

    Joined:
    Jun 4, 2013
    Messages:
    39
    Location:
    White Bear, MN
    Boat Model and Year:
    1994 Grand Sport
    Ski Team:
    Ski Otters
    Talk to skidim, but the short answer is, you probably won't find a replacement. You're likely looking at retrofitting to a carb/distributor if it's ignition/computer related. And is it the ECM or one of the coil packs that's melting? The coil packs had a tendency to melt.
     

Share This Page